Everpure 325, 327 Power Requirements, Water Requirements, Country Volts Frequency Hz Current Amps

Page 7

Cold Drink Center (327/328) Operator’s Guide

Initial Set-up

Power Requirements

This merchandiser requires power as shown in the following table. NOTE: Each merchandiser should have its own electrical circuit.

Power Requirements

Country

Volts

Frequency (Hz)

Current (Amps)

 

 

 

 

 

 

 

 

U.S., Mexico, and Canada

115

60

20

 

 

 

 

International

230

50

13 - 16

 

 

 

 

This merchandiser is supplied with a service cord for the country of use and is ter- minated in a grounding type plug. The wall receptacle used for this merchandiser must be properly polarized, grounded, and of the correct voltage. Operating the merchandiser from a source of low voltage will VOID YOUR WARRANTY. Each merchandiser should have its own electrical circuit and that circuit should be pro- tected with a circuit breaker or fuse conforming to local regulations.

Voltage Check - Place the leads of a voltmeter across the LINE (LIVE) and NEU- TRAL terminals of the wall receptacle. The voltmeter should indicate 110-130 volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230 volt, 50 Hz loca- tions.

Polarity Check - Place the leads of a voltmeter across the LINE (LIVE) and GROUND terminals of the wall receptacle. The voltmeter should indicate 110-130 volts ac for 120 volt, 60 Hz locations, or 220-240 volts ac for 230 volt, 50 Hz loca- tions.

Noise Potential Check - Place the leads of a voltmeter across the NEUTRAL and GROUND terminals of the wall receptacle. The voltmeter should indicate 0 volts ac. A measurement greater than 1.5-2.0 volts ac could result in problems for the merchandiser's electronic circuitry caused by electrical noise.

Any deviation from these requirements could result in unreliable performance from your merchandiser.

Water Requirements

If your location has chemically softened water, one of the following steps is advised:

•Have a non-softened supply line run to the merchandiser

•Contact your local water filter supplier for information and suggestions

Well water can also be used in the Cold Drink Center. However, you should have it checked for levels of carbonates and alkalies. Contact your water filter supplier if these values are relatively high.

Water Pressure

Minimum water pressure: 20 psi (138.0 KPa) at 1/2 gallon/minute

Maximum water pressure: 80 psi (522.0 KPa) at 1/2 gallon/minute

3280020

Page 1

August, 2003

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Page Crane Merchandising Systems Parts and Support Table of Contents Factory Default Throw Times and Volumes View Diagnostic Messages Page Water Pressure Power RequirementsWater Requirements Country Volts Frequency Hz Current AmpsPositioning The Merchandiser Final InstallationSupply Line Requirements Flushing Water Supply LineMechanism Open the cab- inet door Load the coinMonetarySCREW door Install Options Everpure Water Filter Installation Hydrolife Filter Installation Load the cup mechanism Get The Machine Ready To Vend DrinksBag-in-box machines Syrup tank machinesObserve Proper Hygiene do not Touch the Cups Set up the CO2 tank Cold Drink Center 327/328 Operator’s Guide Handle as shown. Once BrixAdjustments and Minor Maintenance Refills Press Water pump starts, and the display showsLimit Screw see Warning Adjusting Screw Priming Switch Adjusting Screw Lock Set the Main Switch to the on up position Press Then Getting Around Programming The Cold Drink CenterFunction Keys DisplaysOther Keys Some Conventions Helpful HintControl Panel Switch Functions Explained Message if desired see Edit Custom Message on SureVendOr after being downloaded into a Enter a NEW Supervisor Code Gain Access to the Supervisor ModeSupervisor Mode Only Follow the steps in Gain Access To The Supervisor Mode onUsage Enter a NEW Data Recall CodeExamples Press Consult your DEX supplier before choosing this option SET Talker ModeSET Printer or DEX Mode To turn the talker option on or OFFSET DEX Options Printer mode onlyMechanism choice Select Display LanguageSelect Bill Validator and Options List of bills. See Initial Setup Of NonStandard Bill ValidaTor on Options on page 28 , to select Initial Setup of Nonstandard Bill ValidatorSelect Monetary Options Select Card Reader and OptionsSome examples Example If setting isExample SET UP Winner Mode Selections. Press SET UP MUG DiscountDisable Selections in the Merchandiser This display means that all regular size selections a F areThis will reload the fac SET UP CUP SizesDisplay momentarily shows This will reassignFor the selection Pressing SET UP a DrinkAppear View and change the settings for syrup View and change the settings for ice throw timeSyrup Throw Still and Carb Ice Extra Ice Factory Default Throw Times and VolumesCup Size Volume Time Sec Special SelectionsPress Until something like Displays. Press Blended DrinksSelect To use. For example, set percentage plus to This meansPress To select the type of pumps in your machine Configure Pump TypeSpritz Drinks SetSET UP Automatic Delivery Door Options Configure Number of SelectionsAbcdef Assign CUP Sizes to Selections Supervisor Mode OnlyOptional or Mandatory Surevend Turn Surevend on or OFFXxxxxx represents the current software version number SET UP the Surevend ANTI-JACKPOT TimerView Software Version Receives changeSET MONTH, DATE, and Year SET the Time of DAYSET Daylight Savings Time Options SET TIME-OF-DAY Free Vending SET TIME-OF-DAY Inhibit VendingSET TIME-OF-DAY Discount Vending XX is the currently set start Time Interval EditingPress the number of the time interval you This display tells you whetherNow shows Stop press X.XX===Display the factory-set message, press Select AN OUT-OF-SERVICE MessageSelect a Standby Message Machine Press Then pressCharacter is displayed Select a Freevend MessageEnd Of Message Character ShortcutDrink 0. Press To view the rest of the available selections View Machine Configuration SettingSetting Press Automatic vend doorPress To view the rest of the available selections View CUP Sizes Assigned to SelectionsPayout Coins Press Then press Until the display shows something likeSET Prices View Nonresettable Sales and Vend DataPress Display shows XX.XX is a dollar and cents View Total Sales by Selection Both CUP Sizes View Data Four Different WaysView Total Paid Sales View Total Sales by Drink SizeView Total Paid Sales by Price Line View Total Sales by Individual SelectionTo view the total sales of each large cup selection Clear Paid Sales Data only Clear ALL Resettable DataView Amount in Coin BOX Not Shown if Zero Not Shown If Zero View Amount in ValidatorView Freevend Sales by Time Interval View Free Vends Not Shown If Zero View Discount Sales by Time IntervalView Winners Not Shown If Zero View Time Data 1100 am View Total Unpaid SalesView Total Unpaid Vends At 942 amView Number of Test Vends Gain Access To The Supervisor Mode onView Machine ID Number View Number of CUP Ring Cycle Failures View Home Switch USE Related to SurevendCycled. Check the cup ring adjustment see Cup mechanism View CUP Ring Cycles Related to SurevendDisplay shows You may now test vend Vend modeTest Vend Selections and Verify Credit Added Test the DisplayTest Throw Carbonated Water Test Drop a CUPTest the Automatic Delivery Door Test Throw Still WaterTest the ICE Maker Test the Syrup PumpsTest the Carbonator At this Pail and dump its contents. The display will showFill during the Coolsan process Read With the time message transposedInput Screen 1 Definitions Test Various Switches and SensorsInput Screen 2 Definitions Press , then press until the display shows View Surevend Average Calibration ValueThen press Until the display shows View Diagnostic MessagesDisplay shows FINISHED. Reconfigure the merchandiser Settings price, time, monetary options, messages, etcError is corrected. Check for bill stuck in the acceptance Keyswitch input is active and configured as an inhibitRect config number directly on this screen without further Power OFF and then onDownload Data to a Pdcd SET Freevend Options Cold Drink Center 327/328 Operator’s Guide Index Page Polarity Check Supervisor Total Sales by Selection View Terms and Conditions of Sale

325, 327 specifications

Everpure is known for its commitment to providing high-quality water filtration solutions, and their 327 and 325 series are prime examples of this dedication. Designed primarily for commercial use, these models are crafted to enhance the flavor of beverages and ensure safe, crystal-clear drinking water.

The Everpure 327 is engineered specifically for applications like espresso machines, commercial coffee brewing, and other foodservice needs. It minimizes scale buildup and helps prevent corrosion, preserving the integrity and efficiency of expensive equipment. The filter uses a unique blend of activated carbon and a proprietary ion-exchange resin, which effectively reduces contaminants such as chlorine, sediment, and particulate matter. This not only enhances taste but also contributes to a cleaner and longer-lasting appliance.

Meanwhile, the Everpure 325 serves as a trusted solution for foodservice operations that require high-quality filtered water. Featuring similar filtration technologies, it prioritizes the removal of undesirable tastes and odors while also tackling unwanted chemicals such as cysts and lead. The 325 model is versatile and can handle a variety of applications, making it ideal for establishments such as restaurants, cafes, and bars.

One standout feature of both models is their exclusive Micro-Pure technology. This technology works to inhibit the growth of bacteria and other microorganisms within the filter, promoting a healthier environment and reducing the risk of contamination. Additionally, the filters are designed for easy installation and maintenance, providing a user-friendly experience for operators.

Both the Everpure 327 and 325 are built with a focus on durability and reliability. They come with a long-lasting filter life, which minimizes the need for frequent replacements, thus saving on operational costs. Their capacity to provide consistent water quality means operators can focus more on serving their customers rather than worrying about water quality issues.

In summary, the Everpure 327 and 325 series stand out for their advanced filtration technology, which effectively improves taste and quality while ensuring equipment longevity. With features aimed at optimizing performance and safety, these models are indispensable for any commercial kitchen or foodservice operation looking to provide the best to its customers.
Top Page Image Contents