Cleaning and care
Cleaning the ice cube tray
Before the ice cubes drop down into the drawer, they are collected in a tray in the ice cube maker.
This tray should be cleaned regularly to remove any stale ice or water.
Connect the appliance to the power supply.
Open the top left drawer slightly.
Press the ON/OFF button on the ice cube maker and the indicator light will come on.
Empty the ice cube drawer.
Press and hold the ON/OFF button on the ice cube maker for approx. 10 seconds (after 1 second the ice cube maker will switch off and the indicator light will go out).
The indicator light will flash.
Within the next 60 seconds, push the ice cube drawer in as far as it will go.
The ice cube tray then rotates into an angled position, which makes it easier to clean.
Wait until the rotation has stopped before continuing.
Now take the ice cube drawer out of the appliance.
Clean the ice cube drawer and the ice cube tray with warm water and some mild dish liquid.
Press the ON/OFF button on the ice cube maker.
Now put the ice cube drawer back in the appliance and close it.
The ice cube tray will now return to its original position.
The ice cube maker will begin to produce ice cubes again within 6 hours.
It is important to clean the ice cube maker if you will not be using it for an extended period of time.
If you used dish liquid to clean the ice cube maker, discard the first three loads of ice cubes! They are not suitable for consumption.
Cleaning the ventilation slits
The ventilation slits should be cleaned on a regular basis with a brush or vacuum cleaner. A
40