Changing the door hinging
Remove the cover .
Now the
Remove the panel .
Push the shock absorber arm as far as possible towards the handle side.
Loosen the three screws on the
In the middle, pry out the housing with the
Then, pry the housing with the
Lay the
Push out the spacer towards the hinge side.
Lay the spacer aside.
Removing the top door of the appliance:
Loosen the cover by carefully sliding a flathead screwdriver from below into the recess.
Remove the cover together with the mounting bracket .
Loosen the mounting bracket from the cover by pushing it slightly to the left and then removing the cover plate towards the front.
Turn the mounting bracket 180°.
Place the cover onto the front of the mounting bracket and push it to the right. The writing must be visible.
Unscrew the bearing mechanism, turn it 180° and replace it on the opposite side. If necessary,
Remove the top cover by pushing it from back to front and lifting it up.
Remove the cover upwards.
58