Miele M.-NR. 04 390 922 Cleaning the water inlet filter, Cleaning the filter

Page 37

Cleaning and care

Cleaning the water inlet filter.

The water valve housing on the inlet hose contains electrical compo- nents and should not be immersed, or run through water.

A filter is incorporated in the inlet hose that is attached to the dishwasher’s main shutoff valve. If your water supply is hard, or the pipes contain sediment; this filter may clog and prevent suffi- cient water from entering the wash cabinet. It can be cleaned as follows:

Cleaning the filter.

Disconnect the dishwasher from the electrical supply (unplug it or shut off the circuit breaker).

Turn off the main shutoff valve and unscrew the inlet hose.

Carefully remove the rubber seal.

Remove the filter using needle nose pliers and clean it by rinsing under running water.

Replace the filter and seal. Make sure they are seated correctly.

Screw the inlet hose back onto the water valve, making certain it is not cross-threaded.

Slowly turn on the valve and test for leaks.

37

Image 37

Contents For dishwashers Contents Integrated i dishwashers Guide to the applianceDishwashers Guide to the appliance Guide to the appliance Important Safety Instructions Important Safety Instructions Disposal of the packing material Caring for the environmentDisposal of your old machine Energy saving washingBefore using for the first time Opening and closing the door Child safety lockTo open the door To close the doorWater softener SettingsWater softener For Hardness Filling the salt reservoir Bypassing the Salt indicator lamp Salt indicatorAdding rinse aid Adding rinse aidSetting the dosage Loading the dishwasher Upper basket Loading examplesBottom basket Cutlery trayLoading the dishwasher Adjustable cup racks Coffee bar Adjusting the upper basket Please note Items not suitable for dishwashersDo not use gels or liquid deter- gents Adding detergentEnergy Saver Program Choosing a programIntensive Program chartUsage Turning on Operating the dishwasherStarting a program Program endTurning off Sequence indicatorInterrupting a program Delay start Additional featuresTop Solo Unloading the dishwasher Cleaning the filters in the wash cabinet Cleaning and careCleaning and care Cleaning the spray arms Cleaning the drain pump and non-re- turn valve Cleaning the filter Cleaning the water inlet filterCleaning the control panel Installing an in-line water filterCleaning the door panel Problems/possible causes Problem solving guideSpray arm indicator lamp flashes Dishwasher does not startWhite residue is visible on cutlery and dishware Dishes are not cleanWater remains in the dishwasher at the end of a program Program update function PC After sales serviceBottle holder AccessoriesInstall the steam deflector, if applicable Dishwasher installationInstall the slides Install the dishwasher under the countertopDishwasher installation If the GDU decor set is being used Installing the control panelAligning the control panel with the drawer fronts Installing the custom door panelAttaching the panel Securing the dishwasher to the countertop Adjusting the door springsFor openings greater than 23 5/8 Cm wide For openings 23 5/8 60 cm wide Installing the toekickFor kitchens utilizing one continuous toekick For kitchens utilizing a non-continuous toekick Adjusting the toekick recessTrimming the toeckick Using an outlet SpecificationsElectrical connection Permanent Connection Hard Wiring Hot water connection PlumbingNew plumbing Existing plumbing Do not shorten the drain hose Drain system specificationsDrain connection Additional note Venting the drainage systemTechnical Data Page Page