Dishwasher installation
3. Installing the control panel.
The control panel and hardware is packaged separately from the dish- washer. It should be installed using the following procedure.
If the GDU decor set is being used,
(to convert an “i” dishwasher to a “U” version), the spacer bars i must first be removed and stored for possible use in the future, (See the separate in- structions for installing the GDU decor set). If the GDU kit is not being used, skip the following step.
To remove the spacer bars from the control panel, place the panel on a table, printed side up, and gently push down on the spacer bars at a
point near the bottom of the control panel. This will release the mounting bolts from their slots.
Install the necessary spacer bars i on the control panel.
Place the seal b onto the ventilation grill. c
Push the ventilation grill c into the metal backing plate.
Place the covers d over the push- button switches.
Install the adapter disc e.
Position the control panel f over the backing plate and fasten it from the inside of the doorg using the six screws provided.
Align and press the program knob onto its shaft h.
46