Electrical connection
Permanent Connection (Hard Wiring).
For hard wiring, the power cord must be disconnected from the terminal box located at the lower left front of the dish- washer, behind the toekick and service panel. Pass the permanent power sup- ply cable through the strain relief and secure it to the terminal box.
Connect:
L1 (Black) to L on terminal block
N(White) to N on terminal block GRND To ground connector
GROUNDING INSTRUCTIONS.
THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
Warning.
Hardwiring the dishwasher should only be done if required by local electrical codes, and then in a manner consistent with those codes. Do not cut the plug off the power supply cord and connect it directly to the house wiring.
55