KODAK ESP 7200 Series All-in-One Printer

Connecting to a wireless network

To connect your printer to an 802.11 wireless (Wi-Fi) network, refer to the following information.

Before you connect

You need:

A computer equipped with a network interface card or wireless networking support.

A working 802.11 wireless network. Kodak recommends that you use a wireless access point/router that uses Dynamic Host Configuration Protocol (DHCP).

Your network name (SSID - Service Set Identifier). You can obtain your SSID from the wireless access point, most commonly a router, using the router’s embedded Web server. See the manufacturer’s documentation provided with your wireless system for more information.

Your Wired Equivalent Privacy (WEP) key or Wi-Fi Protected Access (WPA/WPA2) passphrase.

To be sure to temporarily disable your firewall until the printer is successfully installed and communicating.

Connecting to a wireless network using the WiFi Setup Wizard

You can use the WiFi Setup Wizard on the printer to connect to your wireless network. Read the following procedures and use the one that is appropriate for your network setup.

Connecting to a listed network

See Before you connect to determine what is needed to connect your printer to the network.

To connect to a listed network using the WiFi Setup Wizard:

1.Press Home.

2.Press to select Network Settings, then press OK.

3.With WiFi Setup Wizard selected, press OK.

NOTE: The Wi-Fi radio is turned on automatically when you select WiFi Setup

Wizard.

www.kodak.com/go/aiosupport

5

Page 11
Image 11
Kodak ESP 7200 Series manual Connecting to a wireless network, Before you connect, Connecting to a listed network