Miele M.-NR. 04 390 922 operating instructions Cleaning the spray arms

Page 35

Cleaning and care

Cleaning the spray arms.

On rare occasions particles of food may get stuck in the spray arm jets. They can be easily cleaned as follows:

Remove the lower basket and the cutlery tray (if so equipped). The cut- lery tray frame can be pushed back in.

Unscrew and remove the upper spray arm.

To remove the middle spray arm lo- cated beneath the upper basket, gently push upwards until it engages in the ratchet b, then unscrew it c.

Lift up on the lower spray arm to remove it.

To clean the spray arms, use a pointed object to push the the food particles into the jets.

Rinse under running water to com- plete the process.

After cleaning, replace the spray arms.

Important:

After replacing the spray arms, check that they rotate freely.

35

Image 35
Contents For dishwashers Contents Dishwashers Guide to the applianceIntegrated i dishwashers Guide to the appliance Guide to the appliance Important Safety Instructions Important Safety Instructions Energy saving washing Caring for the environmentDisposal of the packing material Disposal of your old machineBefore using for the first time To close the door Child safety lockOpening and closing the door To open the doorWater softener SettingsWater softener For Hardness Filling the salt reservoir Bypassing the Salt indicator lamp Salt indicatorAdding rinse aid Adding rinse aidSetting the dosage Loading the dishwasher Cutlery tray Loading examplesUpper basket Bottom basketLoading the dishwasher Adjustable cup racks Coffee bar Adjusting the upper basket Please note Items not suitable for dishwashersDo not use gels or liquid deter- gents Adding detergentEnergy Saver Program Choosing a programIntensive Program chartUsage Program end Operating the dishwasherTurning on Starting a programInterrupting a program Sequence indicatorTurning off Delay start Additional featuresTop Solo Unloading the dishwasher Cleaning the filters in the wash cabinet Cleaning and careCleaning and care Cleaning the spray arms Cleaning the drain pump and non-re- turn valve Cleaning the filter Cleaning the water inlet filterCleaning the door panel Installing an in-line water filterCleaning the control panel Dishwasher does not start Problem solving guideProblems/possible causes Spray arm indicator lamp flashesWater remains in the dishwasher at the end of a program Dishes are not cleanWhite residue is visible on cutlery and dishware Program update function PC After sales serviceBottle holder AccessoriesInstall the steam deflector, if applicable Dishwasher installationInstall the slides Install the dishwasher under the countertopDishwasher installation If the GDU decor set is being used Installing the control panelAligning the control panel with the drawer fronts Installing the custom door panelAttaching the panel Securing the dishwasher to the countertop Adjusting the door springsFor openings greater than 23 5/8 Cm wide For kitchens utilizing one continuous toekick Installing the toekickFor openings 23 5/8 60 cm wide For kitchens utilizing a non-continuous toekick Adjusting the toekick recessTrimming the toeckick Electrical connection SpecificationsUsing an outlet Permanent Connection Hard Wiring New plumbing PlumbingHot water connection Existing plumbing Drain connection Drain system specificationsDo not shorten the drain hose Additional note Venting the drainage systemTechnical Data Page Page