Water softener
Setting the water softener for a hard- ness level of 36 - 70 gr/gal requires the following two step procedure:
1.
Turn the dishwasher off.
Turn the program selector knob to the “STOP” position.
Press the “Delay start” and “START” buttons at the same time, while turn- ing the machine on. A “P” and a num- ber will appear in the time display.
Set the program selector knob to the “NORMAL 55/130” position. The number “22” will appear in the time display.
“22” = The factory setting for a water hardness of 22 gr/gal.
Press the “Top Solo” button as often as necessary until the value “36” ap- pears in the display.
Press the “START” button twice to store the “36” in memory.
2.
The water hardness selector in the wash cabinet must be set according to the following chart.
|
|
| value | water |
gr/gal | ppm | °f | for | hardness |
|
|
| program | selector |
|
|
| (Setting) | |
|
|
|
|
|
650- 850 | 65- 85 | 36 | 4 | |
|
|
|
|
|
36 | 5 | |||
|
|
|
|
|
36 | 6 *) | |||
|
|
|
|
|
*) factory setting
Example:
The water hardness is 60 gr/gal.
The water hardness selector in the wash cabinet must be set to 5, (48 - 65 gr/gal).
Using a screwdriver:
Remove the cover from the water hardness selector.
Adjust the water hardness selector as necessary. There will be a click as each setting is reached.
Do not set the selector on setting 1 - 3.
Replace the cover on the water hard- ness selector.
13