Dishwasher installation
4.Aligning the control panel with the drawer fronts.
The control panel can be aligned with the drawer fronts of the kitchen cabinets by adjusting the spacer bars.
Using an 8 mm socket, turn the nut clockwise or counterclockwise until the spacers reach the required height.
If necessary, individual (or all) spacer bars can be removed.
Adjustment range:
from 4 1/2" (112 mm) (control panel without spacer bars)
to 5 3/4" (145 mm) (control panel with four spacer bars).
In special circumstances a fifth spacer bar (optional accessory) can be used to increase the panel height to 6" (154 mm).
After adjusting the control panel height, cut off the plastic screw ex- cess.
5.Installing the custom door panel.
A custom door panel matching the kit- chen cabinetry can be installed on the dishwasher by using the provided
bracket. |
|
|
|
Length: | 21" - 25 | 3/4" | (53.3 - 65.4 cm) |
Width: | 23 | 1/2" | (59.8 cm) |
Note: The maximum panel length is only applicable when no spacer bars are used.
If a Stainless Steel panel is being used, please follow the separate installation instructions included with the panel.
After panel installation, see Step 6 “Ad- justing the door springs”.
Proceed as follows:
Measure the distance (X) between the lower mounting hole on the dish- washer front door (see inset arrow) and the lower edge of the neighbor- ing cabinet door.
47