Switching the appliance ON and OFF
Before first use
The stainless steel surfaces on the inside and outside of the appliance are covered with protective sheeting.
^Do not remove the protective sheeting until the appliance has been installed in its final location.
^Wipe the stainless steel surfaces of the appliance with the enclosed stainless steel cleaning agent directly after removing the protective sheeting.
Important! The stainless steel cleaning agent provides a durable protective film that prevents rapid soiling of the surface!
^Clean the inside of the appliance and the accessories with warm water and dry with a soft cloth.
It is very important to let the appliance stand for 30 to 60 minutes after transport before plugging it in. Failure to do so can prevent the appliance from functioning properly!
Active charcoal filter (Active AirClean Filter)
^Place the enclosed active charcoal filters into the retainer and place the retainer on any shelf in the refrigerator section
(see "Active charcoal filter").
Operating the appliance
To operate this unit, simply touch the sensor buttons as needed.
Switching the appliance ON
The refrigerator and freezer sections are switched on together by touching the ON/OFF button.
^Touch the ON/OFF button until the temperature display lights up.
The temperature display for the refrigerator section shows the actual temperature in the refrigerator section.
If the temperature in the freezer section is above +32°F (0°C), the temperature display will show only dashes. As soon as the temperature drops below +32°F (0°C), the temperature display will show the actual temperature in the freezer section.
The Freezer symbol and the alarm off button will flash until the temperature in the freezer section is cold enough.
The appliance will now start cooling, and the interior light of the refrigerator will come on when you open the door.
Allow the appliance to run for a few hours before placing food in it.
Do not place food in the freezer section until the temperature is cold enough (at least
13