Miele KFN 14943 SD ED installation instructions Remounting the door handles

Changing the door hinging

^ Remove the securing device g.

^Place the panel b onto the soft-close mechanism from above, engaging it at the bottom first and then at the top.

^Close the top door of the appliance.

Remounting the door handles:

The following instructions must be followed when attaching the door handle, otherwise the door seal could be damaged.

^First, loosely screw the door handle onto the opposite side with the two front screws b.

The mounting plate c must be positioned on the door housing in such a way that when the door is closed the mounting plate is aligned with the outside wall of the appliance.

If this alignment is off, you can correct it by

^turning both of the pre-mounted set screws a with a wrench until the mounting plate c is at the correct angle.

^Tighten all 4 screws b.

^From the appliance side, slide the sidebar d onto the guide for the mounting plate, until it audibly engages.

Make sure that the sidebar d does not come in contact with the door seal when the door is opened. This would damage the door seal over time.

If you see that the sidebar is coming into contact with the door seal,

^adjust the mounting plate c again using the set screws a until the mounting plate and the sidebar d are at the correct angle and the sidebar no longer touches the seal when the door is opened.

58