Miele DG 1050 manual Before using for the first time, Setting the water hardness, Hardness Display

Before using for the first time

Setting the water hardness

The steam oven is set at the factory to water hardness setting IV (Very hard 4).

If your water hardness level differs from this, you will need to re-programme the appliance.

You can use the test strip supplied to check the water hardness level, or your local water supplier will be able to advise you on the water hardness of your area.

The water hardness is shown as settings I to IV equivalent to the German scale 1 to >21 °dH (0.2 >3.8 mmol/l).

Hardness	Display	Hardness
level		range
I (soft)	1	1-7 °dH
		(0.2-1.3
		mmol/l)
II (medium)	2	8-14 °dH
		(1.4-2.5
		mmol/l)
III (hard)	3	15-21 °dH
		(2.7-3.8
		mmol/l)
IV (very	4	>21 °dH
hard)		(above 3.8
		mmol/l)

Proceed as follows:

Before you begin, ensure that the appliance is switched off.

^Press the function selector in and turn it anti-clockwise slightly.

^Then release the function selector. "P 1" will appear in the display.

^Turn the function selector until "P 3" appears in the display.

^Confirm your selection by pressing the function selector.

A "4" and the k symbol will appear in the display.

^Turn the function selector until the water hardness level you want appears in the display, e.g. "3" for hard.

^Confirm your selection by pressing the function selector.

"P 3" will appear in the display.

^Press the function selector until the display goes out.

14