HP SureStore 4215w, SureStore 7215w Viewing Current Scsi Address Settings, Scsi Status Indicators

Operating the Library

Setting and Viewing SCSI IDs

Interpreting SCSI Bus Status Indicator LEDs

Each SCSI bus has an LED to indicate the bus status.

Table 3-3	SCSI Status Indicators
		Indication	Status
	Steady green		Port active and OK. Internal (on-board) termination
			enabled.
	Flashing green		Port active and OK. Internal (on-board) termination
			disabled.
	No light		Port not active or not configured.
	Flashing red		Bus mismatch or loss of external termination power.
	Flashing yellow		Bus off-line for on-line drive replacement.
	Viewing Current SCSI Address Settings
	1 2 → ADMIN * → SCSI IDs * → VIEW IDs *
	To view the current SCSI address settings:
	1.	Verify that the drive status displays. If not, press CANCEL until it does.
	2.	Press NEXT until ADMIN * displays, then press ENTER.
	3.	Enter the three-part numerical password (see “Entering the Administration
		Menu Password” on page 3-9).
	4.	Press NEXT until SCSI IDs * displays, then press ENTER.
	5.	SET IDS * displays. Press NEXT until VIEW IDS * displays, then press ENTER.
	6.	BUS # LIB ID # or BUS # DRV # ID * displays. (BUS # LIB ID # stands for
		the current SCSI ID of the robotics controller. BUS # DRV # ID # is the current
		SCSI ID setting for the displayed drive number and its associated BUS#.)
	7.	Press NEXT or PREV to scroll through the current address settings.
	8.	Press CANCEL until the next operation to perform displays, or until the drive
		status (library “ready” state) displays.

3-14