HP SureStore 7215w, SureStore 4215w, SureStore 7115w Power On the System, Install Backup Software

NOTE

Installing the Tape Library

Step 7: Power On the System

Step 7: Power On the System

1.Plug the power cord into a grounded outlet.

2.Turn on the power switch.

Initially SELF TEST and NOT READY, and then NOT READY and INVENTORY CHECK alternately appear in the display window on the library. After the power-on test completes (approximately 1.5 minutes), the drive status information displays. (See “Understanding Display Window Messages” on page 3-4.)

If the drive status information does not display, the power-on test was not successful and DEVICE FAILED displays. See “Troubleshooting” on page 3-38 for troubleshooting procedures.

3.Turn on other peripherals (if any).

4.Turn on the host system.

Install Backup Software

Follow the instructions provided with your backup software to configure it to your library. Several trial versions are provided with the library for your evaluation.

Verify Installation With TapeAssure

HP TapeAssure is a software utility that tells you quickly and easily whether your configuration is correct and whether the tape drive is ready for use with backup software. Your backup software must be TapeAlert compatible for you to receive these messages (compatible packages will display the HP TapeAlert logo). For the latest list of backup packages that support TapeAlert, refer to HP’s World Wide Web site (http://www.hp.com/go/tape).

Installation

1-27