Operating the Library

Setting Configuration Options

Setting Configuration Options

1 2 → ADMIN * → CONFIG *

You can set certain options to customize the way the library operates. These options are called configurations.

To change a configuration:

1.Verify that the drive status displays (if not, press CANCEL until it does).

2.Press NEXT until ADMIN * displays, then press ENTER.

3.Enter the three-part numerical password (see “Entering the Administration Menu Password” on page 3-9).

4.INFO * displays. Press NEXT until CONFIG * displays, then press ENTER.

5.Press NEXT or PREV until the name of the configuration you wish to set displays, then press ENTER. If the configuration has multiple settings, the current setting flashes. Otherwise, the configuration option is set and a confirmation message displays. (Configuration options are described on the following pages.)

If the current configuration setting is flashing, press NEXT or PREV until the desired setting displays, then press ENTER. OPTION SAVED displays.

6.Press CANCEL to return to the drive status (“ready” state).

The table on the following page describes the available configurations.

Operation Library

3-25