HP SureStore 7115w, SureStore 4215w manual Setting Scsi IDs, Scsi Address Configuration Options

Operating the Library

Setting and Viewing SCSI IDs

Setting SCSI IDs

1 2 → ADMIN * → SCSI IDs * → SET IDs *

A SCSI ID is required for the robotics controller and each drive. The default IDs are shown in Table 3-1 on page 3-11.

The following configuration choices are available:

Table 3-2	SCSI Address Configuration Options
		Number of	SCSI Bus Addresses Available
		Drives
	1		13 addresses are available on bus 1. (Drive 1 uses one address
			and the library controller uses 1 address.)
	2		If buses 1 and 2 are connected to separate host SCSI cards:
			• 13 addresses are available on bus 1 for other devices.
			• 14 addresses are available on bus 2 for other devices.
			If buses 1 and 2 are daisy-chained:
			• 12 addresses are available on the bus for other devices.

To change the current SCSI address settings:

1.Verify that the drive status displays (if not, press CANCEL until it does).

2.Press NEXT until ADMIN * displays, then press ENTER.

3.Enter the three-part numerical password (see “Entering the Administration Menu Password” on page 3-9).

4.Press NEXT until SCSI IDs * displays, then press ENTER.

5.SET IDs * displays. Press ENTER.

LIB BUS # ID # or DRV # BUS # ID # displays. LIB BUS # ID # stands for the current SCSI ID of the robotics controller. DRV # BUS # ID # is the current SCSI ID setting for the drive number and its associated bus #.

6.Press NEXT until the setting to change displays, then press ENTER.

3-12