SCCG50 & SCCP50
Service Manual
Door Covering
Door Panel | Custom Panel |
The ice machine is supplied without a conventional door covering so it can be decorated to the user’s preference. Scotsman offers several coverings including white, black and stainless steel. In addition, a custom built panel can be placed onto the door.
Door Panel Attachment
To attach a Scotsman supplied panel:
Note: If door swing is to be changed, it must be done before panel is attached.
The panel will be held on by 6 sheet metal screws and 2 machine screws.
1.Remove the gasket and retain for later use.
2.If the door panel is stainless steel, remove any plastic covering the stainless steel panel.
3.Place the panel onto the outside of the door, and secure it to the door using two machine screws, located at the left center and right center.
4.Fasten the panel to the door using the 6 sheet metal screws. In the hinge area, use the outermost screw holes.
5.Place the covers over the hinge areas, and secure each cover to the door using a sheet metal screw.
A custom panel of wood or other material not exceeding 15 lb can be attached to the door. Attachment is from the ice side of the door. Holes are provided in the door for this purpose.
See instructions in information packet to create and attach a custom panel:
6.Insert hole plug over screw installed in step 5.
7.Return the gasket to its original position.
June 2008
Page 6