Scotsman Ice SCCG50, SCCP50 service manual Removal and Repair

					SCCG50 & SCCP50
					Service Manual
Removal and Repair
Bin Thermostat			9.		Reverse to reassemble.
1.	Disconnect electrical power.			Curtain
			1.		Shut unit off.
			2.		Loosen both thumbscrews holding curtain
		Electrical Shock
				bracket to freezing chamber.
		Hazard.
		Disconnect electrical
		power before	3.		Pull out and remove curtain with bracket from ice
		beginning removal		machine.
			4.		Reverse to reassemble.
2.	Remove service panel.
3.	Remove back panel.			Spray Platform
			1.		Remove curtain.
Note: If unit is built in it must be pulled out to
change the bin thermostat.			2.		Lift spray platform up until it disconnects from its
4.	Pull cap tube out from the back of the ice			fitting.
storage bin and cap tube holder.			3.		Pull forward and remove from the ice machine.
5.	Remove two screws and the bin thermostat		4.		Reverse to reassemble.
contact section from its mounting bracket.
6.	Disconnect two wires from the bin thermostat			Water Pump
contact section and remove the thermostat from			1.		Remove spray platform
the ice machine.
7.	Reverse to reinstall.		2.		Remove back panel.
Inlet Water Solenoid Valve				Note: If unit is built in it must be pulled out to
				change the water pump.
1.	Disconnect electrical power.
			3.		Disconnect power and ground wires from pump
2.	Remove service panel.			motor.
3.	Shut water supply OFF.		4.		Rotate pump body CW and lift up to remove it.
4.	Disconnect inlet water supply tube from inlet		5.		Reverse to reassemble.

water solenoid valve.

5.Unplug wire harness from valve coil.

6.Remove two screws holding valve to chassis.

7.Squeeze hose clamp larger and push away from solenoid valve outlet.

8.Pull hose from outlet of valve.

June 2008

Page 28