SCCG30 & SCCP30
Service Manual
How to clean the condenser and winterize.
Condenser cleaning | Winterizing |
The condenser is like the radiator on a car, it has fins and tubes that can become clogged with dirt and lint. To clean:
1.Remove the kickplate and front service panel.
2.Locate the condenser surface.
1.Clean the ice making system.
2.Open the door and push and release the On/Off switch to turn the machine off.
3.Turn off the water supply.
4.Drain the water reservoir by removing the rubber cap under the reservoir - it's near the back wall of the ice storage bin.
Rubber Cap
3. Vacuum the surface, removing all dust and lint.
Caution: Do not dent the fins.
4.Return the kickplate and front service panel to their original positions. Fasten them to the cabinet using the original screws.
5.Disconnect the incoming water line at the inlet water valve.
6.Open the door, push and release the on/off switch to turn the machine on.
7.Blow air through the inlet water valve; a tire pump could do the job.
8.Drain pump models should have about 1/2 gallon of RV antifreeze (propylene glycol) poured into the ice storage bin drain.
Note: Automotive antifreeze must NOT be used.
9. Switch off and unplug the machine.
September 2009
Page 16