FRONT VIEW OF MOTOR
FROM INSIDE OVEN CAVITY
MOTOR ROTATES CLOCKWISE
12.Slide blower onto motor shaft until hub is flush with end of shaft, then tighten setscrews.
13.Adjust motor position until blower is parallel to motor mounting plate as outlined in Blower Adjustment under Service Procedures and Adjustments.
14.Position motor mounting plate on the rear wall and secure with nuts and washers.
15.Replace the baffle panel and snorkel.
16.Replace the air baffle on the rear wall at the lower right hand corner.
17.Remove cardboard from the bottom of the oven cavity.
18.Install racks.
19.Check oven for proper operation.
OVEN DOORS AND BEARINGS
Disconnect the electrical power to the machine and follow lockout / tagout procedures.
1.Remove the top front cover and bottom front cover as outlined under Covers and Panels.
2.Remove the door switch lever.
3.Remove the lower door seal strip to expose the mounting screws of the door assembly.
4.Remove the two lower sill bolts by the lower door shaft and the four countersunk screws from the lower sill.
A.The door assembly is heavy and will drop down once the last screw is removed. If removing the door assembly without assistance, the ignition cable, flame sense lead and gas manifold should also be removed to avoid damage to these components.
5.Tilt the top of the door slightly forward and lift the door up until the bottom of the door shaft clears the opening in the sill.
6.Lay the door flat to prevent damage.
– 15 –