GE JCBP68, JCBP67, JCBP65 Using the self-cleaning oven, Consumer Support Troubleshooting Tips Care

Instructions

Using the self-cleaning oven.

Never force the latch handle. Forcing the handle will damage the door lock mechanism.

and Cleaning Operating Instructions Safety

	Before a Clean Cycle
	We recommend venting your kitchen
	with an open window or using a
	ventilation fan or hood during the
	first self-clean cycle.
	Remove the racks, broiler pan, broiler
	grid, all cookware and any aluminum foil
	from the oven.
Wipe up heavy soil on the oven	NOTES:
bottom.	■ If your oven is equipped with shiny,
	silver-colored oven racks, remove them
	before you begin the self-clean cycle.
	■ If your oven is equipped with gray
	porcelain-coated oven racks, they may
	be left in the oven during the self-clean
	cycle.
	Soil on the front frame of the range and
	outside the gasket on the door will need
(on some models)	to be cleaned by hand. Clean these areas
	with hot water, soap-filled steel wool pads
	or cleansers such as Soft Scrub®. Rinse
	well with clean water and dry.

Do not clean the gasket. The fiberglass material of the oven door gasket cannot withstand abrasion. It is essential for the gasket to remain intact. If you notice it becoming worn or frayed, replace it.

Wipe up any heavy spillovers on the oven bottom.

Make sure the oven light bulb cover is in place and the oven light is off.

IMPORTANT: The health of some birds is extremely sensitive to the fumes given off during the self-cleaning cycle of any range. Move birds to another well- ventilated room.

Consumer Support Troubleshooting Tips Care

How to Set the Oven for Cleaning

Follow the directions in the Before a

Clean Cycle section.

WARNING: The surface units are automatically disabled during the self-clean cycle. Make sure that all surface unit controls are turned off at all times during the self-clean cycle. Any surface unit that is set to an on position, while the self-clean cycle is operating, will automatically come on after the self-clean cycle is finished, and could result in an on, unattended surface unit. Wait until the self-clean cycle is finished to set and use the surface units.

	Latch the door.
	NOTE: Never force the latch. If the oven is
	too hot, you will not be able to slide the
	latch. Allow the oven to cool.
	Touch the CLEAN pad.
	Touch the + or – pads until the
	desired Clean Time is displayed.
	The Clean Time is normally 4 hours. You can
	change the Clean Time to any time between 3
22	and 5 hours, depending on the amount of soil in
	your oven.

Touch the START/ON pad.

The self-clean cycle will automatically begin after CLEAN is displayed and the time countdown appears in the display.

While the oven is self-cleaning, you can touch the CLOCK pad to display the time of day. To return to the clean countdown, touch the CLEAN pad.

The oven shuts off automatically when the clean cycle is complete, and 0:00 will flash in the display.

Slide the latch handle to the left as far as it will go and open the door.

It will not be possible to unlatch the oven door until the temperature drops below the lock temperature and the LOCKED door light goes off.

When the LOCKED door light is off, unlatch the door.