Greenheck Fan PVE-35, PVE-55, PVE-20, PVE-45 manual Modulating Control for FAN Speed

Factory Set Points - continued

Resetting the V1000 drive to factory defaults To reset the V1000 drive back to Greenheck factory defaults go to parameter A1-01 and set it to “2”. Then go to A1-03 and change it to “1110” and press enter. The drive is now reset back to the settings programmed at Greenheck. This option is not available on the J1000.

MODULATING CONTROL FOR FAN SPEED

(0-10 VDC)

	Parameter	Setting
		V1000	J1000
A1-01	Access Level	2	2
b1-17	VFD Start-Up Setting	1	1
C1-01	Acceleration Time	30 sec.	30 sec.
C1-02	Deceleration Time	30 sec.	30 sec.
C6-02	Carrier Frequency	1	1
d2-02	Ref Lower Limit	50%	50%
E2-01	Motor Rated FLA	Motor	Motor
		FLA	FLA
H3-04	Terminal A1 Bias	50%	50%
A1-01	Access Level	0	0

CO2 SENSOR CONTROL FOR FAN SPEED

(1/2 speed WHEN C02 drops below 700 PPM) (FULL SPEED WHEN C02 RISES ABOVE 800 PPM)

	Parameter	Setting
		V1000	J1000
A1-01	Access Level	2	2
b1-01	Reference Source (Frequency)	0	0
b1-17	VFD Start-Up Setting	1	1
C1-01	Acceleration Time	30 sec.	30 sec.
C1-02	Deceleration Time	30 sec.	30 sec.
C6-02	Carrier Frequency	1	1
d1-01	Frequency Reference 1	60 Hz	30 Hz
d1-02	Frequency Reference 2	30 Hz	60 Hz
d2-02	Ref Lower Limit	50%	50%
E2-01	Motor Rated FLA	Motor	Motor
		FLA	FLA
H3-10	A2 Not Used	F	NA
A1-01	Access Level	0	0

multispeed control FOR FAN SPEED

(1/3 or 1/2 speed reduction)

	Parameter	Setting
		V1000	J1000
A1-01	Access Level	2	2
b1-01	Reference Source (Frequency)	0	0
b1-17	VFD Start-Up Setting	1	1
C1-01	Acceleration Time	30 sec.	30 sec.
C1-02	Deceleration Time	30 sec.	30 sec.
C6-02	Carrier Frequency	1	1
d1-01	Frequency Reference 1	60 Hz	60 Hz
d1-02	Frequency Reference 2	40 Hz	40 Hz
d1-03	Frequency Reference 3	30 Hz	30 Hz
d1-04	Frequency Reference 4	60 Hz	60 Hz
d2-02	Ref Lower Limit	50%	50%
E2-01	Motor Rated FLA	Motor	Motor
		FLA	FLA
H1-04	Multfunction Input Sel 4	3	3
	(Terminal S4)
H1-05	Multifunction Input Sel 5	4	4
	(Terminal S5)
H1-06	Multifunction Input Sel 6	5	NA
	(Terminal S6)
H3-10	A2 Not Used	F	NA
A1-01	Access Level	0	0

Model PVe Heat Recovery Unit 13