2b
SETTING THE BURNER MINIMUM (Valves may vary)
When switching from one type of gas to another, the minimum flow rate must also be correct: the flame should not go out even when passing suddenly from maximum to minimum flame.
To regulate the flame follow the instructions below:
Rapid and triple ring burners
–Light the burner
–Set the gas valve to LO position
–Remove the knob
–With a thin screwdriver, turn the regulation screw until adjustment is correct (Fig. 2.7a or 2.7b). On some valves, you need to pass by the hole of the microswitch (Fig. 2.7a) to turn the regulation screw.
Inside crown of DUAL burner
–Light the DUAL burner
–Set the gas valve to SIM position
–Remove the knob
–Using a screwdriver turn the screw H until the correct setting is obtained (fig. 2.8).
Outside crowns of DUAL burner
–Light the DUAL burner 
–Set the gas valve to LO position
–Remove the knob
–Using a screwdriver turn the screw G until the correct setting is obtained (fig. 2.8).
For LP/PROPANE gas, tighten the regulation screws completely.
Regulation screw |
Fig. 2.7a |
OR |
regulation screw |
Fig. 2.7b |
H |
G |
Fig. 2.8 |
21