Reverse Osmosis Water Supply
IMPORTANT:
The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.) If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):
•Check to see whether the sediment fi lter in the reverse osmosis system is blocked. Replace the fi lter if necessary.
•Allow the storage tank on the reverse osmosis system to refi ll after heavy usage.
•If your refrigerator has a water fi lter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water fi lter.
If you have questions about your water pressure, call a licensed, qualifi ed plumber.
USING THE COLD WATER
DISPENSER
Using the Water dispenser (RF221**)
Place a glass underneath the |
|
|
water outlet and push gently |
|
|
against the water dispenser |
|
|
lever with your glass. Make |
| 02 |
sure the glass is in line with |
| |
the dispenser to prevent the | PUSH | OPERATING |
refrigerator or installed a new |
| |
water from splashing out. |
|
|
If you have just installed the |
|
|
water fi lter, Flush 11 L through fi lter before use (fl ush approximately 6 minutes). Make sure water fl ows cleanly before drinking.
If you have a long vacation or business trip, CAUTION close the water valve and shut off the water
supply to the Refrigerator. This will help prevent accidental leakages.
Water clouding phenomenon
All water provided to refrigerators fl ows through the core fi lter which is an alkaline water fi lter. In this process, the pressure in the water that has fl owed out of the fi lter gets increased, and oxygen and nitrogen become saturated. When this water fl ows out in the air, the pressure plummets and the oxygen and nitrogen get supersaturated so that they turn into gas bubbles. The water could look misty due to these oxygen bubbles.The water may look temporarily cloudy due to these oxygen bubbles. After a few seconds, the water will look clear.
The water tank’s capacity is approximately 1 L.
Please wait 1 second before removing the cup after dispensing water to prevent spills.
operating _21
2012.7.3 10:53:33 AM |