Mechanical Disassembly
Water Filter
The water filter is located in the upper
1. Turn the water filter 1/2 turn counterclockwise and pull it down.
2. To install the filter, align the indication mark (unlock position) and push it up while turning 1/2 turn clockwise until the lock position is aligned. Do not over tighten.
Upper Ductwork
1. Remove the screw caps (2) and screws (5).
2. Slide the upper fan ductwork out while disconnecting the wire connector(lamp and thermistor).
Evaporator Cover in the Refrigerator
1.Pull out the screw cap and remove the screw.
2.Remove the lamp cover by unlocking the tabs and pulling the cover down.
3.Remove the water tank from the evaporator cover by unscrewing the screws (2).
4.Remove the screws (6) at the evaporator cover and the two fixed screws of the wire connector cover.
5.Take off motor and lamp wire connector located on the upper liner.
6.Remove the duckwork of the evaporator fan in the direction of the arrow as shown.
Evaporator Fan Motor
The evaporator fan is located in the middle rear of the freezer. This fan circulates cold air in the freezer.
1.Remove screws (4) located at the four corners of the fan bracket.
2.Take the fan motor assembly off.
16