Cleveland Range KET-3-T manual Assembly, Electrical, Wire Connection

ASSEMBLY
Table-Top Models (3, 6 & 12 gallon)
1.25"		14.5"	1.25"
1.25"
		KET-3-T
10"		KET-6-T	12.5"
		KET-12-T
1.25"				5/16" - 18
		18"		threaded
				bushings
1.25 "	B				C
			TKET-3-T
10"			TKET-6-T		12.5"
		TKET-12-T
1 1/4"
			A
Model #			A	B	C
TKET-3-T			18"	2.25"	1.25"
TKET-6-T			24"	4.63"	4.63"
TKET-12-T			30"	7.75"	7.75"

Base Mounting Diagram

Table-top models (3, 6 & 12 gallon - single and twin) must be positioned on a firm, level stand, or existing counter top, and bolted in place. These models are supplied with four threaded mounting bushings welded to the underside of the base. An optional support stand with level adjustable legs is available. Once the kettle is secure, screw tilt handle into the threaded hole provided at the right side of kettle.

Floor Type Leg Mount Models (20 gallon)

1.25"	28.5"	2.25"
1.25"
	KET-20-T
12"		14.5"
1.25"
	32"

Base Mounting Diagram

Position on a firm, level surface, and bolt two flange feet in place. Once the kettle is secure, screw tilt handle into the threaded hole provided at the right of kettle.

ELECTRICAL

ENSURE THE ELECTRICAL SUPPLY MATCHES THE KETTLE'S REQUIREMENTS AS STATED ON THE RATING LABEL.

This kettle is built to comply with applicable standards of manufacturers. Included among these approval agencies are UL, NSF, ASME/Ntl. Bd., CSA, ETL, and others. Many local codes exist, and it is the responsibility of the owner and installer to comply with these codes.

The electrical supply must match the power requirements specified on the kettle’s rating plate. The copper wiring must be adequate to carry the required current at the rated voltage. Refer to the Specification Sheet for all electrical specifications.

Note: Maximum voltage for LVD (low volt directive for Europe) to be 440 volts for CE marked appliances.

WIRE CONNECTION

If unit does not have cord and plug option, remove the four screws securing the console cover and remove the cover. A wiring diagram is affixed to the underside of the cover. Feed permanent copper wiring through the cut-out in the rear or bottom of the console, and fasten to the three connection terminal block, which is mounted on the top of the console’s control panel. Be sure to connect the ground wire to the separate ground terminal connector (ground lug). Replace console cover and secure it with the four screws.

THREE	BLACK		BLUE	RED	SINGLE	BLACK		BLUE	RED
PHASE					PHASE
RED					RED
YELLOW					YELLOW
BLACK					BLACK
		L1	L2	L3			L1		L2

The kettle is wired for 3-phase operation at the factory. For single phase operation, rewire the terminal block to that shown in the above diagram.

2