Alto-Shaam 100-HW/D4, 400-HW/D4 R V I C E, Tools Required 2mm allen hex wrench, Service Parts

CAUTION

THIS SECTION IS PROVIDED FOR THE ASSISTANCE OF QUALIFIED SERVICE TECHNICIANS ONLY AND IS NOT INTENDED FOR USE BY UNTRAINED OR UNAUTHORIZED SERVICE PERSONNEL.

CALIBRATION PROCEDURES

Every unit is calibrated at the factory. Only a qualified service technician should calibrate the unit in the field if necessary.

SHOCK RISK WARNING: Unit must be disconnected from power source before making adjustments or calibrating switch.

TOOLS REQUIRED: 2mm allen (hex) wrench

S E R V I C E

DANGER

DISCONNECT UNIT FROM

POWER SOURCE BEFORE

CLEANING OR SERVICING.

SERVICE PARTS

LOC P/N DESCRIPTION

1.CD-3232 CORDSET 120V (100-HW & 200-HW)

2.CD-33367 CORDSET 120V (300-, 400- & 500-HW)

3.CD-33840 CORDSET 208-240V

4.	CD-3922	CORDSET 230V
5.	LI-3027	WHITE POWER LIGHT 110V
6.	LI-3951	WHITE POWER LIGHT 250V

7.PE-29421 PANEL OVERLAY 1-10

8.TT-34982 THERMOSTAT, 120V

9.TT-34981 THERMOSTAT, 240V

10.KN-26568 KNOB

8

9

1

2

3

4

		5
10	7	6

Part numbers and drawings are subject to change without notice..

CABLE HEATING REPLACEMENT SERVICE KITS		100-HW	200-HW	300-HW	400-HW 500-HW
	KIT NUMBER	4877	4878	4880	4881	5 4880
SERVICE KIT INCLUDES:
CB-3045	CABLE HEATING ELEMENT	37 ft	67 ft	132 ft	144 ft	120 ft
CR-3226	RING CONNECTOR	2	4	8	12	8
IN-3488	INSULATION CORNER	8 ft	8 ft	8 ft	8 ft	8 ft
BU-3105	SHOULDER BUSHING	2	4	8	12	8
BU-3106	CUP BUSHING	2	4	8	12	8
SL-3063	INSULATING SLEEVE	2	4	8	12	8
TA-3540	HIGH TEMP ELECTRICAL TAPE	1 roll	1 roll	1 roll	1 roll	1 roll
ST-2439	10.32 STUD	2	4	8	12	8
NU-2215	HEX NUT	4	8	32	24	32

Hot Food Drop-In Well Operation & Care Manual • 15