Carrier 17 installation instructions Typical 19EX Installation

RIG MACHINE COMPONENTS Ð Refer to instructions on page 5, Fig. 6-8, and Carrier certi®ed drawings for ma- chine component disassembly.

IMPORTANT: Only a quali®ed service technician should disassemble and reassemble the machine. After reas- sembly, the machine must be dehydrated and leak tested.

When rigging components separately, the open drive (17EX) motor must be removed to avoid overturning.

Do not attempt to disconnect ¯anges while the machine is under pressure. Failure to relieve pressure can result in personal injury or damage to the unit.

Before rigging the compressor, disconnect the wires leading from the power panel to the control center at the power panel.

NOTE: Wiring for sensors must be disconnected. Label each wire before removal (see Carrier certi®ed drawings).

Detach all transducer and sensor wires at the sensor, then clip all wire ties necessary to remove the wires from the heat exchangers.

19EX

					LEGEND
1	Ð Refrigerant Liquid Line to Economizer/		15	Ð	Motor Sight Glass (Not Shown)	27	Ð	Oil Cooler
		Storage Vessel	16	Ð	Oil Filter	28	Ð	Isolation Valves (Not Shown)
2	Ð	Cooler Suction Pipe	17	Ð	Oil Level Sight Glasses (2)	29	Ð	Refrigerant Filter Drier
3	Ð	Compressor Suction Elbow	18	Ð	Cooler Relief Valves (Not Shown)	30	Ð	Local Interface Display Control Panel
4	Ð	Condenser	19	Ð	Oil Heater (Not Shown)	31	Ð	Economizer/Storage Vessel
5	Ð	Condenser Discharge Pipe	20	Ð	Auxiliary Power Panel	32	Ð	Rigging Guide (Not Shown)
6	Ð	Compressor Discharge Elbow	21	Ð	(Field Wiring Terminals)	33	Ð	Economizer/Storage Vessel
7	Ð	Guide Vane Actuator			Pumpdown Unit (Not Shown)	34	Ð	Relief Valves
8	Ð Economizer Gas Line to Compressor		22	Ð	Low-Side Float Box Cover			Cooler
9	Ð	Gear Inspection Cover	23	Ð	Refrigerant Liquid Line to Cooler	35	Ð	High-Side Float Box Cover
10	Ð	2-Stage Hermetic Compressor	24	Ð	Oil Drain and Charging Valve	36	Ð	Take-Apart Connections
11	Ð Condenser Waterbox Vent (Not Shown)		25	Ð	Oil Pump	37	Ð	Cooler Waterbox Vent
12	Ð	Condenser Marine Waterbox	26	Ð	Refrigerant Charging/Service	38	Ð	Cooler Marine Waterbox
13	Ð	Hermetic Compressor Motor			Valve 10 (Not Shown)	39	Ð	Cooler Waterbox Drain
14	Ð Compressor Motor Terminal Box					40	Ð	Condenser Waterbox Drain
		(Not Shown)

Fig. 2 Ð Typical 19EX Installation

4