Instructions for the installer
5 ADAPTATION TO DIFFERENT TYPES OF GAS
Before performing any cleaning or maintenance work, disconnect the appliance from the electrical socket.
The hob has been inspected for G25 (2L3B/P) natural gas at a pressure of 25 mbar. For functioning with other types of gas the nozzles must be replaced and the primary air adjusted.
To replace the nozzles and regulate the burners, you have to remove the top as described in the following paragraph.
5.1Removing the separable control panel (models with
separable control panel)
1.Remove the knobs and the knob guard tube “A” by pulling them up;
2.Use a crosshead screwdriver to remove the screws and the two cylindrical supports “B”;
3.Raise the
4.In models with electric hotplate, the body of the pilot light has to be removed to free the control panel;
5.2Removing the hob (models with integrated control panel)
1.Remove the knobs, the griddles, the burner caps, the flame caps and the two rear plugs;
2.Remove the screws “A” which fix the burner supports;
3.Raise the hob, sliding it off the ignition plugs and/or the thermocouples and the gas tap rods;
5.3Regulation for LPG
Check that the connection has been made as described in the “Gas connection” section.
Undo the screw “D” and push the air regulator “C” fully down. Use a spanner to remove the nozzles “B” and fit those of suitable type
31