Smeg A2EA manual Removing the door, Oven door gaskets, Lubrication of gas taps

Page 30

Instructions for the user

11.2 Removing the door

Open the door completely and fit the pins (supplied) into the holes from the inside. Close the door to an angle of about 45°, lift it and remove it from its seat. To replace, fit the hinges into the grooves provided, then lower the door until it comes to rest and extract the pins. If the pins are lost, two screwdrivers can also be used.

11.3 Oven door gaskets

The door gaskets can be dismantled for thorough cleaning of the ovens. Before removing the gaskets the oven doors must be removed as previously described. With the doors removed, raise the tabs at the corners as shown in the figure.

11.4 Lubrication of gas taps

With time it may happen that the gas taps get blocked and hard to turn. Clean them inside and re-grease them. This operation must be done

by a specialised technician.

Image 30

Contents Contents NEVER UNPLUG BY PULLING ON THE CABLE Introduction1. INSTRUCTIONS FOR SAFE AND PROPER USE NEVER ATTEMPT TO REPAIR THE APPLIANCEIntroduction THE PLATE MUST NOT BE REMOVED2.1 Electrical connection Instructions for the installer2. INSTALLATION OF THE APPLIANCE This rating plate must never be removedFor operation on 380-415V3N∼: use an 2.2 Ventilation requirementsInstructions for the installer For operation on 380-415V2N∼: use anInstructions for the installer diagram3.1Replacement of nozzles on the hob 3. ADAPTATION TO DIFFERENT TYPES OF GASInstructions for the installer Instructions for the installer 3.2 Burner and nozzle characteristics table3.3Arrangement of burners on cooking hob BURNERS4.2 Regulation of minimum for LPG 4.1 Adjustment of minimum for natural gas4. FINAL OPERATIONS 4.3 Positioning and levelling of the appliance4.4Mounting the rear top upstand Instructions for the installer5.1 Front control panel Instructions for the user5. DESCRIPTION OF CONTROLS COOKING HOB BURNER COMMAND KNOBMAIN OVEN FUNCTION SWITCH KNOB Instructions for the userAUXILIARY OVEN THERMOSTAT KNOB Instructions for the user 5.2 Electronic Programmer5.2.1 Clock adjustment LIST OF FUNCTIONS5.2.3 Automatic cooking Instructions for the user5.2.2 Semiautomatic cooking the end of cooking time press the key5.2.8 Cancellation of set data 5.2.5 Adjusting alarm volume5.2.6 Switching off the alarm Instructions for the user6.3 Diameter of containers 6. USE OF THE COOKING HOB6.1 Lighting of the cooking hob burners Instructions for the user7.2 Oven Light 7.1 Warnings and general advice7. USE OF THE OVENS 7.3 Cooling fan7.4 Storage compartment Instructions for the user8. AVAILABLE ACCESSORIES Accessories on RequestInstructions for the user FUNCTION SWITCH 9. COOKING HINTS9.1 Traditional cooking main and auxiliary ovens THERMOSTAT SELECTOR SWITCH FROM 50 TO 250CFUNCTION SWITCH 9.2 Hot-aircooking main oven9.3 Grill cooking main and auxiliary ovens THERMOSTAT SELECTOR SWITCH FROM 50 TO 250CFUNCTION SWITCH THERMOSTAT SWITCH FROM 50 TO 200C 9.4 Hot-airgrilling main oven9.5 Delicate cooking auxiliary oven FUNCTION SWITCH9.6 Defrosting main oven FUNCTION SWITCH THERMOSTAT SWITCH IN POSITIONInstructions for the user 9.7 Recommended cooking table TRADITIONAL COOKINGGRILLING Instructions for the userFIRST COURSES HOT-AIRCOOKINGInstructions for the user MEAT10.2Cleaning of cooking hob components 10.CLEANING AND MAINTENANCE10.1 Cleaning stainless steel 10.1.1 Ordinary Daily Cleaning10.2.2 Burner caps, flame cap crowns and burners 10.3 Cleaning of the ovenInstructions for the user 10.2.3 Ignition plugs and thermocouples10.4 Door glass 10.3.1Assembling the self-cleaninglinersInstructions for the user Instructions for the user 11.EXTRAORDINARY MAINTENANCE11.1 Replacement of light bulbs Only use oven bulbs T 300C11.4 Lubrication of gas taps 11.2 Removing the door11.3 Oven door gaskets Instructions for the userPage 914773043/ A