Smeg DI614H instruction manual User instructions, Using the water softening system

Page 23

User instructions

9. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

Adjust the water softening system;

Add the regenerating salt;

Add the rinse aid and detergent.

9.1 Using the water softening system

The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with an automatic

softening system which uses a specialSALT regenerating salt to reduce the hardness

of the water.

The dishwasher is factory set for water hardness level 3 (average hardness 41-60°dF24-31°dH).

When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.7 Kg of salt in grains. Some models are equipped with an optical no-salt indicator. In these models, the cap of the salt container contains a green float which descends as the salt concentration in the water drops. When the green float can no longer be seen through the transparent cap, the container must be topped up with regenerating salt. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening.

When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container.

Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated.

Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely.

23

Image 23
Contents Guide for Using the Dishwasher and the Washing Program Page Rqwhqwven Safety instructions Safety instructions Aquastop Models Installation instructions Drain Connection Connecting to the Water SupplyWater supply connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFor Great Britain only When Cleaning and Maintaining the ApplianceBuzzer enabling Instructions for the UserLanguage depending on model Water hardnessInformation display Description of controlsControl panel Programme Selection introduction Switching onRapid programming Re-using last programme usedStandard programmes Programme Table Special Programme Features Changing the Programme Norm Button D Button EInstructions for the User To Save Energy and Protect the Environment User instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent User instructions General warnings and recommendations Items which are not dishwasher-safe Lower Basket Using the basketsEN 50242 Standard Loads for Certification Bodies Loading the Lower Basket Cutlery Basket Loading the Upper Basket Upper BasketAdjusting the Upper Basket Cleaning the Spray Arms Cleaning the Water Intake FilterProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Acquastop failure TroubleshootingSafety device tripped Temperature sensor k.oLevel pressure switch k.o Technical Data Page Page 19 590 1216