Smeg DI614H instruction manual Level pressure switch k.o

Instructions for the User EN

MALFUNCTION - DESCRIPTION

Litre counter k.o. (for the relevant models only)

The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the programme and switch off the dishwasher. Switch the dishwasher back on, programme it again and start the washing cycle. If the problem persists, contact the after-sales service.

Alternate washing failure (for the relevant models only)

Interrupt the programme and switch off the dishwasher. Switch the dishwasher back on, programme it again and start the washing cycle. If the problem persists, contact the after-sales service.

Level pressure switch k.o.

Contact the after-sales service.

•"Acquastop failure”, “Safety device tripped”, “Heating k.o.”, “Temperature sensor k.o.”, “Alternate washing failure” and “Level pressure switch k.o.” trigger an immediate termination of the programme in progress.

•"Tap turned off” and “Drain blocked” interrupt the programme in progress and then continue it as soon as the cause of the problemme has been dealt with.

•"Litre counter k.o.” is displayed at the end of the cycle, which however is completed since the problem does not interfere with operation of the dishwasher.

To reset an alarm, proceed as follows:

•open or close the door, or switch the appliance off and back on. The dishwasher can now be programmed again.

If the malfunction persists, contact your authorised Service Centre.

40