
Step 7
Step 8
Refer to Figure 16. Attach 200107 support pairs
•Use 7/8 by
Note: Angles are attached edge out with flat of angle facing inward.
301786
Figure 16
Align panning frame/azimuth pivot assembly by swinging panning frame through its entire arc. Slightly snug panning frame/pivot assembly hardware, and again swing panning frame through its entire arc. Continue this procedure until mounting hardware is ready for tensioning.
Note: Do not tighten hardware on 301786/201022 azimuth pivot assemblies at this time.
21 | Installation Procedures |