Andrew 9.3-Meter ESA manual 20008A

Step 5

Step 6

Attach 200108 supports to 200063/200064 rear pad assemblies and 200088 joint assembly as shown in Figure 10.

•Use 7/8 x 2-1/4 in (57 mm) bolts and nuts

•Insert bolt from inside of joint assembly to outside of support

•Supports should be installed back-to-back with the edges forward and the flats of angles facing rear

Figure 10

Attach 200873 supports between angle pairs as shown in Figure 11. Select correspond- ing mounting holes so that 200873 supports are parallel to 200114A beam assembly.

•Use 7/8 x 2-3/4 in (70 mm) hardware

•Supports attached with edges inward and flats facing up.

20008A

Figure 11

16 Installation Procedures