Andrew 9.3-Meter ESA manual Step

Step 3

Step 4

Raise 200114A beam assembly to upright position and attach 200109 supports to 200068 joint assembly as shown in Figure 8.

•Use 7/8 x 2-1/4 in (57 mm) bolts and nuts

•Insert bolts from 200068 joint assembly to supports

•Supports should be installed back-to-back with the flat of angle facing upwards

•Tighten supports until assembly can support itself

Figure 8

Attach 200063/200064 rear pad assemblies to 200109 supports as shown in Figure 9.

•Use 7/8 x 2-1/4 in (57 mm) bolts and nuts

•Insert bolt from inside of rear pad assembly to outside of support

•Supports should be installed back-to-back with the edges forward and the flats of angles facing rear

Figure 9

15 Installation Procedures