Andrew 9.3-Meter ESA manual Recommended Tools, Tool Size Quantity

Recommended Tools

NOTE: Failure to follow an installation procedure could result in damage to equipment or personal injury.

Additional warnings will be displayed throughout this manual for your awareness. These warnings can be identified in warning boxes as shown in the following sample.

Andrew disclaims any liability or responsibility for the results of improper or unsafe installation, operation, or maintenance practices.

Andrew supplies all appropriate hardware/parts required for the installation of your 9.3- Meter Earth Station Antenna. All tools necessary for the installation process should be provided by the installation crew. Andrew recommends the following tools to be used for a proper installation of the 9.3-Meter Earth Station Antenna.

Tool	Size	Quantity
Open End or Combination Wrenches	1/4 Inch	2
	5/16 Inch	2
	3/8 Inch	2
	7/16 Inch	2
	1/2 Inch	2
	9/16 Inch	2
	3/4 Inch	2
	7/8 Inch	2
	1-1/16	2
	1-1/8 Inch	2
	1-7/16 Inch	2
	1-5/8 Inch	2
	1-7/8 Inch	2
Drive Sockets	5/16 Inch	2
	7/16 Inch	1
	1/2 Inch	2
	9/16 Inch	2
	3/4 Inch	2
	15/16 Inch	2
	1-1/16 Inch	1
	1-1/8 Inch	2
	1-7/16 Inch	1
	1-7/8 Inch	1
Breaker Bar	3/4 Inch	2
Crane	18 Ton Minimum Capacity, extended end	1
Nylon Web Slings (2000 pound breaking strength) 3 Inch by 20 Foot		4
Rope or Cord (2000 pound breaking strength)	50 Foot	1
Shackles	5/8 Inch	4
Ladder	10 Foot Step	2
Ladder	18 Foot Extension	2
Drift Pin	5/8 to 7/8 Inch	2
Drift Pin	1/4 to 1/2 Inch	2
Spud Wrench	1-1/8 Inch	2
Screw Drivers	Standard/Phillips	1
Bucket Truck		1
Allen Wrenches	Set	1
Torque Wrench	250 ft/lb	1
Adjustable Wrenches	8 and 12 Inch	1
Drill	Electric	1
Tape Measure (or other measuring device)	Standard	1
Felt-tip Marker (or other marking device)	Standard	1
Hammer	Standard	1
Rubber Mallet	Standard	1
Pry Bar	Standard	1
Tin Snips	Standard	1
Safety Gloves (each installer)	Standard	1

Table 2-1. Recommended Tools

7 Getting Started