Peavey PV 35XO manual Mode Switch, Subs OUT Summed Switch

Page 9

10

12

14

16

8

9

11

13

15

MID GAIN CONTROL (Channel 1) (8)

This controls the output level of the channel 1 mid frequency signal (signal above the selected low/mid crossover point and below the selected mid/high crossover point) present at the channel 1 mid output XLR.

HIGH GAIN CONTROL (Channel 1) (9)

This controls the output level of the channel 1 high frequency signal (signal above the selected mid/high crossover point) present at the channel 1 high output XLR.

OUTPUT MUTE SWITCHES (Channel 1) (10)

This mutes the output of the associated level controls.The Mute function will be indicated by the illumination of the red LED located above the associated switch.

MODE SWITCH (11)

This switch selects between stereo 3-way operation and mono 5-way operation.The red LED above the Mode switch indicates mono mode.When this switch is engaged, the crossover is in mono operation.

SUBS OUT SUMMED SWITCH (12)

This switch combines the sub frequencies of both channel 1 and channel 2 into a single output, which allows you to use half as many amplifiers as you would with two channels of subs.The Summed function will be indicated by the illumination of the red LED above the switch.

INPUT GAIN CONTROL (Channel 2) (13)

This control is used to optimize the channel 2 gain between the mixer and the power amps for channel 2.The control range is between -12 dB and +12 dB.

CLIP INDICATOR (Channel 2) (14)

When illuminated, the red Clip indicator located to the upper right of the Input Gain control indicates that the signal is clipping.This clipping may be heard as distortion.While there should be no problem if this indicator flashes occasionally, it should never flash constantly or stay illuminated.This could result in impaired system performance and possible loudspeaker damage.

CROSSOVER SELECTOR CONTROL (Channel 2 lows/mids) (15)

This allows users to choose their desired crossover points for lows and the low side of the mids for channel 2.The control range is between 80 Hz and 900 Hz or 800 Hz and 9 kHz, depending on the position of the Range switch.

RANGE (x10) SWITCH (Channel 2 lows/mids) (16)

This switch multiplies the value indicated on the Crossover Selector control for the lows and the low side of the mids times 10.When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9 kHz. Range x10 is indicated by the illumination of the red LED above the switch.

9

Image 9
Contents PV35XO 3-Way Stereo/4-Way or 5-Way Mono Crossover Page Sound Level dBA, Slow Response Important Safety Instructions⁄ 4 oder weniger Wichtige Sicherheitshinweise⁄ 4 ou inférieur Instructions Importantes DE Securite⁄ 4 o menos Instrucciones Importantes Para SU SeguridadDescription FeaturesRange x10 Switch Channel 1 lows/mids Clip Indicator Channel 1Range x10 Switch Channel 1 mids/highs Input Gain Control Channel 1Subs OUT Summed Switch Mode SwitchPower Switch IEC Mains Connector Clip Indicator Input Gain ControlLOW Gain Control Range x10 Switch mids/high-mids LOW-MID Gain ControlCrossover Selector Control mids/high-mids Crossover Selector Control high-mids/highs Range x10 Switch high-mids/highsMID Gain Control HIGH-MID Gain ControlLOW Output InputLOW-MID Output MID OutputPV35XO Merkmale BeschreibungCLIP-ANZEIGE Kanal 1 INPUT-GAIN-REGLER Kanal 1CROSSOVER-WAHLSCHALTER Kanal 1 Tiefen/Mitten RANGE-SCHALTER x10 Kanal 1 Tiefen/MittenSUBS-OUT-GESAMTSCHALTER MODE-SCHALTERPOWER-SCHALTER LOW Output Kanal 1 Input Kanal 1MID Output Kanal 1 High Output Kanal 1IEC-NETZSTECKER INPUT-GAIN-REGLER CLIP-ANZEIGELOW-GAIN-REGLER LOW-MID-GAIN-REGLER CROSSOVER-WAHLSCHALTER Mitten/hohe MittenRANGE-SCHALTER x10 Mitten/hohe Mitten RANGE-SCHALTER x10 hohe Mitten/Höhen CROSSOVER-WAHLSCHALTER hohe Mitten/HöhenMID-GAIN-REGLER HIGH-MID-GAIN-REGLERDiese Funktion steht beim Mono-Betrieb nicht zur Verfügung IEC-NETZSTECKER Wege-Stereo/4-Wege- oder 5-Wege-Mono Frequenzweiche Caractéristiques FrançaisIndicateur D’ECRETAGE Clip Canal 1 Controle DE Gain D’ENTREE Canal 1Controle DE LA Frequence DE Filtre Canal 1 Grave/Médium Selecteur DE Filtre x10 Canal 1 Grave/MédiumSelecteur DE Sortie Basses Frequences Couplees Selecteur DE ModeInterrupteur D’ALIMENTATION Sortie BASSES-FREQUENCES Canal 1 Entree Canal 1Sortie Frequences Medium Canal 1 Sortie HAUTES-FREQUENCES Canal 1Connecteur D’ALIMENTATION IEC Controle DE Gain D’ENTREE Indicateur D’ECRETAGE ClipControle DES Basses Frequences Controle DES Frequences MEDIUM-GRAVE Controle DE LA Frequence DE Filtre Médium/Médium-aiguesSelecteur DE Filtre x 10 Médium/Médium-aigues Selecteur DE Filtre x10 Médium-aigues/Aigues Controle DE LA Frequence DE Filtre Médium-aigues/AiguesControle DES Frequences Medium Controle DES Frequences MEDIUM-AIGUESSortie BASSES-FREQUENCES EntreeSortie Frequences MEDIUM-GRAVES Sortie Frequences MediumConnecteur D’ALIMENTATION IEC Filtre actif 3-voies stéréo/5-voies mono Características DescripciónLED Indicador DE Saturación Canal 1 Control DE Ganancia DE Entrada Canal 1Control Selector DE Crossover Canal 1 graves/medios Interruptor DE Rango x10 Canal 1 Graves/MediosInterruptor DE Salida DE Suma DE Subs Interruptor DE ModoInterruptor DE Encendido Salida DE Graves Canal 1 Entrada Canal 1Salida DE Medios Canal 1 Salida DE Agudos Canal 1Conector Principal DE Corriente Control DE Ganancia DE Entrada LED Indicador DE SaturaciónControl DE Ganancia DE LA Señal Grave Control DE Ganancia DE LA Señal GRAVE-MEDIA Control Selector DE Crossover medios/medios-agudosInterruptor DE Rango x10 medios/medios-agudos Interruptor DE Rango x10 agudos-medios/agudos Interruptor DE Rango x10 medios-agudos/agudosControl DE Ganancia DE LA Señal Media Control DE Ganancia DE LA Señal MEDIA-AGUDASalida DE Graves EntradaSalida DE GRAVES-MEDIOS Salida DE MediosFiltro Crossover de 3 Vías Estéreo/4 o 5 Vías Mono Page Page Page Peavey Electronics Corporation Limited Warranty