Peavey PV 35XO manual Crossover Selector Control high-mids/highs, Range x10 Switch high-mids/highs

1822

17 19 20 21 23

CROSSOVER SELECTOR CONTROL (high-mids/highs) (17)

This allows users to choose their desired crossover points for the high side of the high-mids and the highs.The control range is between 80 Hz and 900 Hz or 800 Hz and 9 kHz, depending on the position of the Range switch.

RANGE (x10) SWITCH (high-mids/highs) (18)

This switch multiplies the value indicated on the Crossover Selector control for the high side of the high-mids and the highs times 10.When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9 kHz. Range x10 is indicated by the illumination of the red LED above the switch.

MID GAIN CONTROL (19)

This controls the output level of the mid frequency signal (signal above the selected low-mid/mid crossover point and below the selected mid/high-mid crossover point) present at mid output XLR.

HIGH-MID GAIN CONTROL (20)

This controls the output level of the high-mid frequency signal (signal above the selected high-mid/mid crossover point and below the selected high crossover point) present at high-mid output XLR.

HIGH GAIN CONTROL (21)

This controls the output level of high frequency signal (signal above the selected high-mid/high crossover point) present at high output XLR.

OUTPUT MUTE SWITCHES (Channel 2) (22)

This mutes the output of the associated level controls.The Mute function will be indicated by the illumination of the red LED located above the associated switch.

POWER SWITCH (23)

This 2-position rocker switch applies mains power to the unit when in the ON position. Power ON is indicated by red LED located above the Power Switch.

WARNING

THE ON/OFF SWITCH IN THIS APPARATUS

DOES NOT BREAK BOTH SIDES OF THE MAINS.

HAZARDOUS ENERGY MAY BE PRESENT INSIDE

THE ENCLOSURE WHEN THE POWER SWITCH IS

IN THE OFF POSITION.

14