Anritsu S331C, S113C, S332C, S114C manual Keypad Hard Keys, Clear

0-9

These keys are used to enter numerical data as required to setup or per-

form measurements.

+/–

The plus/minus key is used to enter positive or negative values as required

to setup or perform measurements.

￿

The decimal point is used to enter decimal values as required to setup or

perform measurements.

ESCAPE

Exits the present operation or clears the display. If a parameter is being

CLEAR

edited, pressing this key will clear the value currently being entered and

restore the last valid entry. Pressing this key again will close the parame-

ter. During normal sweeping, pressing this key will move up one menu

level.

UP/DOWN

Increments or decrements a parameter value. The specific parameter value

ARROWS

affected typically appears in the message area of the LCD.

ENTER

Implements the current action or parameter selection.

ON

Turns the Anritsu Site Master on or off. When turned on, the system state

OFF

at the last turn-off is restored. If the ESCAPE/CLEAR key is held down

while the ON/OFF key is pressed, the factory preset state will be restored.

SYS

Allows selection of display language and system setup parameters.

Choices are OPTIONS, CLOCK, SELF TEST, STATUS and

LANGUAGE.