Anritsu S332C, S113C, S114C, S331C manual InstaCal Error Messages, Installed

Chapter 2 Functions and Operations

Table 2-3.Range Error Messages (2 of 2)

CANNOT ZERO Attempting to perform a Power Monitor zero adjust function with no

NO DETECTOR RF detector connected to the Site Master.

INSTALLED

CANNOT ZERO Attempting to perform a Power Monitor zero adjust function with an

INPUT SIGNAL input of greater than –20 dBm.

TOO HIGH

POWER MONITOR Attempting to enter Power Monitor mode with no Option 5 installed.

OPTION NOT

INSTALLED

InstaCal Error Messages

If an InstaCal module that has not been characterized in more than one year is connected to the Site Master, the follow message will be displayed:

The InstaCal Module Connected, S/N XXXXX Was Characterized more than 1 year ago. Characterization date

Current SiteMaster Date

You are advised to return this InstaCal module to the factory for re-characterization.

Press ENTER to continue, see manual for details.

Return the InstaCal module to the factory for re-characterization in order to ensure contin- ued accurate measurements.

If the serial number of the connected InstaCal module does not match the serial number stored in the Site Master, the following message is displayed:

The InstaCal characterization data stored in the SiteMaster is for a module different than the one currently connected. SiteMaster contains data for InstaCal module S/N: Currently connected InstaCal Module S/N:

Would you like to overwrite the previously loaded InstaCal characterization?

Press the YES soft key to update the stored InstaCal characterization to use the currently connected module.

Press the NO soft key to keep the stored InstaCal characterization.

2-22