Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Disconnect power.
|
| G |
C | D | E |
|
|
A 
B
F
A. White wires | E. Home power supply cable or | |
B. Black wires | power cord accessory kit | |
C. UL listed wire connector | F. UL listed or CSA approved | |
D. Green (or bare) ground wire | ½" strain relief | |
G. Green ground screw | ||
|
2.Use UL listed wire connectors and connect white wires (A) together.
3.Use UL listed wire connectors and connect black wires (B) together.
WARNING
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in terminal box.
Failure to do so can result in death, fire, or electrical shock.
4.Connect green (or bare) ground wire from power supply to green ground screw in terminal box and securely tighten.
5.Install terminal box cover.
6.Reconnect power.
Complete Installation
1.Replace the 2 bottom panels.
a.Place the back of the panel into the rear channel and push the panel toward the back of the range hood until the tabs on the front of the panel clear the front mounting flange.
b.Push the front of the panel up into the front mounting flange until the panel tabs align with the slots in the front mounting flange. Release the panel so the tabs lock the panel in place.
2.Replace grease filter. See the “Range Hood Care” section.
3.Check the operation of the range hood fan and light. See “Range Hood Use” section.
If range hood does not operate, check to see whether a circuit breaker has tripped or a household fuse has blown. Disconnect power and check wiring connections.
NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.
11