Whirlpool UXT5230AYW installation instructions To Replace the Filter, Replacing a Halogen Lamp

To Replace the Filter:

1.To reinstall the filter, the single slot opening on the long edge of the filter is to be toward the front of the range hood. Place the back edge of the filter into the channel at the rear of the range hood.

2.Pull the filter retainer toward the front of the range hood and push the front of the filter up into place.

3.Release the filter retainer. It will spring back into place to secure the filter.

4.Replace the screw into the filter retainer.

Replacing a Halogen Lamp

Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new lamp, do not touch lamp with bare fingers. Replace lamp, using tissue or wearing cotton gloves to handle lamp.

If new lights do not operate, make sure the lamps are inserted correctly before calling service.

1.Disconnect power.

2.Use a flat-blade screwdriver and gently pry the light cover loose.

3.Remove the lamp and replace with a 120-volt, 40-watt maximum, halogen lamp made for a G-9 base.

4.Replace the light cover.

5.Reconnect power.

13