Aiwa XM-M25 manual To switch to the 24-hour standard, Press Sleep while pwessing Shift

	C2Q0
	QC2C2
	Oom -		CLOCK
2,3	090	-	SHIFT
	CG35
	QC2Q
1,2,3	OOCJ
	[moo

■c1

[

1 Press CLOCK while pressing SHIFT on the remote control and press 1I SET within 4 seconds.

The hour flashes.

2 Press 44 DOWN or - UP to designate the hour, then press II SET.

The hour stops flashing and the minute starts flashing.

3 Press + DOWN or - UP to designate the minute, then press 11 SET.

The minute stops flashing on the display and the clock starts from 00 seconds.

To display the current time

Press CLO.CK while pressing SHIFT on the remote control. The time is displayed for 4 seconds.

However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCK while pressing SHIFT on the remote control and then press ■ within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

This is caused by a power interruption. The current time needs

If power is interrupted for more than approximately 24 hours, ~ all settings stored in memory after purchase need to be reset.

1

1

2

The unit can be turned off automatically at a specified time.

Use the remote control.

1 Press SLEEP while pwessing SHIFT.

SLEEP

2 Within 4 seconds, press - or ~ to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.	m

Specified time

I

To check the time remaining until the power is turned off

Press SLEEP once while pressing SHIFT. The remaining time is displayed for 4 seconds.

To cancel the sleep timer

Press SLEEP twice while pressing SHIFT so that “SLEEPoFF appears on the display.

ENGLISH16