Dacor EF36RNBSS, IF36LNBOL, IF36RNBOL, EF36LNBSS Complete Installation, Water System Preparation

Installation Instructions

Complete Installation

1.Turn the water supply line valve to the “Open” position.

2.Turn the refrigerator switch to the on position. See Power On/ Off Switch in the use and care manual for instructions. Wait a few minutes. Check the water line connections for leaks.

3.Remove all boxes, parts packages and packing materials from the interior of the refrigerator. See the Care and Cleaning section in the use and care manual for instructions. Remove the protective film and cardboard from the grille and doors or door frame, depending on your model.

4.Install the shelves and bins in the refrigerator and freezer compartments.

5.The controls are preset at the factory to the midpoint setting. Check to be sure that the compressor is operating properly and that all the lights are working.

6.Flush the water system before use. See Water System Preparation.

To get the most efficient use from your new built-in refrigerator, read your use and care manual. Keep Installation Instructions and the use and care manual near the refrigerator for easy reference.

Water System Preparation

Please read before using the water system.

Immediately after installation, follow the steps below to make sure that the water system is properly cleaned.

1.Turn off the ice maker. Slide the ice maker On/Off control, located on the left-hand side of the ice bin, to the off (down) position as shown.

Any questions or problems with this installation should be directed to your Dacor dealer or the Dacor Customer Service Team at

(800)793-0093. You may also visit our web site at www.Dacor.

com.

If you need service, be sure to have the model and serial numbers when you call. You’ll find these numbers on the serial number label, located on the right hand side of the fresh food compartment.

A

A. On/Off control

NOTE: If your model has a base grille filter system, make sure the base grille filter is properly installed.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

2.Turn on the ice maker. Slide the ice maker On/Off control, located on the left-hand side of the ice bin, to the on (up) position. Please refer to Ice Maker and Storage Bin section in the use and care manual for further instructions on the operation of the ice maker.

ƒƒ Allow 24 hours to produce the first batch of ice. ƒƒ Discard the first three batches of ice produced.

20