Siemens DataNET Hub (DNH) user manual CE Installations, CE Installation Kit Instructions

CE Installations

Description	This section should be used for installation sites that must conform to CE
	(Conformite Europeene) Certification. Typically, this does not apply to
	installations outside the EC unless the equipment was purchased with
	the explicit requirements and expectations that it shall conform to EC
	Electromagnetic and Radio Frequency Interference (EMI/RFI) rejection
	specifications.

CE Installation Kit

Instructions

Available from Siemens Applied Automation CE Installation Kit P/N 2020264-001. This kit has all the parts for all the installations referenced in this section.

The following information pertains to CE Installation of General Purpose, Zone 1 and Division 2 Equipment. For Zone 1 Installations, all cabling is terminated in the DNH Zone 1 Enclosure.

Installation with Metallic	The preferred method is to route the field wiring in metallic conduit. If
Conduit	metallic conduit is used, unshielded power and signal wires can be used.
	The power and signal wires (DataNET or Ethernet) must be routed in
	separate conduit.
	Using flexible conduit and/or armored cable is equivalent to using “steel
	conduit”. Flexible conduit or armored cable must have its flexible conduit
	and/or armoring conductivity 360-degree terminated at its entry to the
	DNH enclosure (or bulkhead).
Installation without	If conduit is not used, the following installation practices must be used to
Metallic Conduit	ensure that the CE certification remains valid:
	1. A shielded power cord or cable must be used for the input power
	wiring. The shield must be terminated at the DNH in a 360-degree
	termination at the enclosure (bulkhead); use Siemens Applied Auto-
	mation P/N 2015729-001 contained in the CE Installation Kit or an
	equivalent part. For Zone 1 Installation use Siemens Applied Auto-
	mation P/N 1311001-014 Installation Kit.
	2. The DataNET copper cables shields must be terminated in a 360-
	degree termination at the enclosure (or bulkhead; use Siemens Ap-
	plied Automation P/N 2015729-001 contained in the CE Installation
	Kit or an equivalent part). For Zone 1 Installation, use Siemens Ap-
	plied Automation P/N 13111001-014 Installation Kit.

2000585-001 Installation • 23