Establishing a Connection, Continued
Password Format
A password name can consist of any combination of alphanumeric char- acters. The alphanumeric name must have a minimum of five and a maximum of twenty characters. The DNH Communication board is shipped from the factory with the word “password” entered as the de- fault password name.
How to Change | The user can change the password name at any time. To do this login |
Password | using the current password then type: “password stand stand”. Where |
| the word stand is your new password entered twice to verify that it was |
| properly entered. |
How to Log Out |
|
You may log out or close the Configuration and Diagnostic program at | |
| any time by typing logout. However, the Configuration and Diagnostic |
| program will automatically log you out after five minutes. |
How to Log On |
|
The following procedure assumes that the HyperTerminal program, re- | |
| siding on your PC, has been configured to communicate with the DNH, |
| and the PC is connected to the DNH ‘A’ or ‘B’ Configuration Port. |
| 1. Open Windows HyperTerminal program. |
| 2. Press ↵ Enter twice |
| The following dialog box appears: |
Data Communications Setup • 55 |
