Siemens DataNET Hub (DNH) user manual Logout Command Netstat Command, Port Command

Command Descriptions, Continued

“logout” Command

“netstat” Command

This command logs the user out of a session. The user must be logged out of the local device to login to a remote device.

This command may be used to display statistics for the DataNET sec- tion. If a link number is given, statistics are displayed for just that link. If no link number is given, summary statistics for all DataNET links are given. If the keyword “clear” is given, the statistics counters are reset to zero:

netstat dn [link] [clear]

Example:local> netstat dn clear

SCC 2: Subordinate Link 9. RUNNING

SCC 3: Principal (mux)Links 1 through 8. RUNNING

SCC 4: Cross-link	Link 10.	RUNNING
DataNET Statistics for all DN Links
Frames Sent		4967
Frames Sent/Retried		60
Frames Sent/Redirected		60
Frames Sent w/Errors		0
Frames Sent UnACKnowledged		0
Frames Received		4372
Frames Receiver Not Ready		0
Frames Received w/Errors		0
Link down		54
local>

“port” Command

This command will enable or disable normal DataNET communication on individual ports. Before placing a port into “test” mode (see test com- mand below), the port must first be taken offline with:

port stop num

where num is a port number, 1 through 9.

This command may also be used to reset a port that has been automati- cally taken out of service by the hub after detection of a DataNET topol- ogy loop:

port start num

This will re-start normal DataNET communications on a port.

80 • Command Summary 2000585-001