CONNECTING A PORTABLE DISHWASHER
Connecting the dishwasher
1.Run water at faucet until it is hot. Turn water off.
2.Pull hoses out of their storage compart- ment on the back of the dishwasher.
NOTE: Make sure the hoses are not kinked or twisted. Kinked hoses reduce washing performance.
3. Pull down on the locking collar while lifting the hose connector onto the faucet adapter.
4.When the connector snaps into place, release the locking collar.
5. Turn the hot water on slowly until it is all the way on.
6. Plug in power supply cord.
7. See the “Starting Your Dishwasher” sec- tion for instructions on how to start
the dishwasher.
Locking collar
Hose connector
Drawing water when dishwasher is connected
You can draw water from the faucet while the dishwasher is connected. Do not draw water while the dishwasher is filling or while water is being pumped out. (This helps pre- vent a low fill when dishwasher is filling
or mixing drain water with fresh water.)
•Press the red button on the hose connec- tor to draw water from faucet. (The faucet is set on hot. Adjust faucet for the water temperature you want.)
NOTE: Turn hot water back on after you draw water from faucet. Turn off cold water.
23