Broan RM60000 manual To Reduce the Risk of a Range TOP Grease Fire

Page 2

! WARNING

! WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty.

2.Before servicing or cleaning unit, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

3.Installation work and electrical wiring must be done by qualified personnel in accordance with all applicable codes and standards, including fire-rated construction codes and standards.

4.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer’s guidelines and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

5.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

6.Ducted fans must always be vented to the outdoors.

7.Do not use this unit with any additional solid-state speed control device.

8. To reduce the risk of fire, use only steel ductwork.

9.This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

a)Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

b)Always turn hood ON when cooking at high heat or when flambeing food (Crêpes Suzette, Cherries Jubilee, Peppercorn Beef Flambé).

c)Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.

d)Use proper pan size. Always use cookware appropriate for the size of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING*:

1.SMOTHER FLAMES with a close-fitting lid, cookie sheet or metal tray, then turn off the burner.

BE CAREFUL TO PREVENT BURNS. IF THE FLAMES DO NOT GO OUT IMMEDIATELY, EVACUATE AND CALL THE FIRE DEPARTMENT.

2.NEVER PICK UP A FLAMING PAN—You may be burned.

3.DO NOT USE WATER, including wet dishcloths or towels—This could cause a violent steam explosion.

4.Use an extinguisher ONLY if:

A.You own a Class ABC extinguisher and you know how to operate it.

B.The fire is small and contained in the area where it started.

C.The fire department has been called.

D.You can fight the fire with your back to an exit. * Based on “Kitchen Fire Safety Tips” published by NFPA.

CAUTION

1.For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.

2.To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

3.Your hood motor has a thermal overload which will automatically shut off the motor if it becomes overheated. The motor will restart when it will be cooled down. If the motor continues to shut off and restart, have the hood serviced.

4.For best capture of cooking impurities, the bottom of the hood should be at a minimum of 24” and at a maximum of 30” above the cooking surface.

5.Two installers are recommended because of the large size and weight of this hood.

6.To reduce the risk of fire and to properly exhaust air, be sure to duct air outside—Do not exhaust air into spaces within walls or ceiling or into attics, crawl space or garage.

7.This product is equipped with a thermostat which may start blower automatically. To reduce the risk of injury and to prevent power from being switched on accidentally, switch power off at service panel and lock or tag service panel.

8.Because of the high exhausting capacity of this hood, you should make sure enough air is entering the house to replace exhausted air by opening a window close to or in the kitchen.

9.To reduce the risk of fire and electric shock, the Broan Elite RM60000 Series hood must be installed with Broan interior blower models RM325H or RM326H; Broan exterior blower models 331H, 332H, 335 or 336; Broan in-line blowers models HLB3, HLB6, HLB9, HLB11. Other blowers cannot be substituted. (Blowers sold separately.)

10.Use with approved cord-connection kit only.

11.Please read specification label on product for further information and requirements.

- 2 -

Image 2
Contents RM60000 Series To Reduce the Risk of a Range TOP Grease Fire Never Pick UP a Flaming PAN-You may be burnedWarranty Series Hood Model RM326HOptional Soffit Chimney RMN Series Model RM325HRMP Series Select Blower Option and Install Ductwork Model HLB3, HLB6, HLB9 or HLB11Installation with Standard 18’’ High OVER-COOKTOP Cabinet Measure InstallationPrepare the Installation Install the Hood Install Backsplash OptionalInstall Wood Mounting Strip Install Transition to ROUGH-IN Plate Interior Blower onlyInstall the Optional Soffit Chimney Install the ROUGH-IN Plate to the Hood ALL BlowersConnect the Wiring ALL Blowers Install the Blower Interior or Exterior BlowerBaffle Filters Install Light Bulbs and Warming LampsInstall Filters USE and Care Operation Service Parts QTY Hood Width Number DescriptionSérie RM60000 Afin DE Réduire LES Risques FEU DE CuisinièreTable DES Matières Garantie Limitée DE UN AN DE BROAN-NUTONEHotte Série Modèle RM326HPlaque Ventilateur Filtres À ChicaneFacultatif COUVRE-CONDUIT Optionnel Série RMNRecouvrement de mur en acier Modèle HLB3, HLB6, HLB9 OU HLB11 Capuchon de toit Conduit rond De 10 po Ventilateur en ligneModèle 331H, 332H, 335 OU Installation Sous UNE Armoire Standard DE 18 PO DE Hauteur Mesurer L’INSTALLATIONPréparer L’INSTALLATION Installer LA Hotte Installer LE Dosseret OptionnelInstaller LA Lisière DE Bois Choisir L’OPTION Ventilateur Intérieur OU ExtérieurBranchement Électrique Tous LES Ventilateurs Installer LE COUVRE-CONDUIT OptionnelInstaller LE Ventilateur Intérieur OU Extérieur Série RMN OptionnelFiltres à chicane Installer LES Ampoules ET Lampes ChauffantesInstaller LES Filtres Entretien Fonctionnement 17. Pièces DE Rechange Pièce DescriptionSerie RM60000 Advertencia Índice DE Materias BROAN-NUTONE Garantía Limitada POR UN AÑOChimenea DE Intrados Opcional Serie RMN Campana Modelo RM326H VentiladorPlaca DEL Ventilador ventilador interior de 1200 pcm et Modelo RM325H VentiladorRemate de pared Ventilador exterior Redondo Modelo HLB3, HLB6, HLB9 O HLB11 Seleccione LA Opción Ventilador Y Instale LOS ConductosModelo 331H, 332H, 335 O Mida LA Instalación Prepare LA InstalaciónInstale LA Campana Instale LA Placa Para Antisalpicaduras OpcionalInstalación DE LA Tira DE Madera Seleccione LA Opción Ventilador Exterior O InteriorInstale EL Ventilador Interior O Exterior Conexión Eléctrica Todos LOS VentiladoresInstale LA Chimenea DE Intrados Opcional Serie RMN OpcionalFiltros de zig zag Instale LOS Bombillas Y Lámparas TermógenaInstale LOS Filtros Mantenimiento Funcionamiento Repuestos CTD Anchura DE LA Campana Pieza Descripción